Can you daisy chain speakers

QSC K. Eventually — after many tens of units — some line-level signal loss will occur, depending on the length of the cable run. With any Post-gain Mix Output, there is always some small noise added due to the signal running through the gain circuitry and this noise will grow with every additional loudspeaker that is daisy-chained.

It is recommended to daisy-chain no more than four 4 units using their Mix Output. This practice is perfectly safe and because you are only running through a single Mix Output, you can daisy-chain many tens of units using the Thru Outputs. Your email address will not be published. All you have to do is locate the correct connectors at the back of the speakers then run signal cables between them.

These procedures also apply for daisy chain monitors on stage. If you want a more detailed explanation of how to set up stage monitors , click on the link as I have dedicated a full article to explain it. The following is a diagram to help explain the steps mentioned above visually for easier understanding.

Just as active speakers have a connection for daisy-chaining several of them together, powered subwoofers do as well. The principle is the same, a signal coming from the mixer, crossover, or speaker management system is looped out for connecting another device.

Connecting two 8-ohm speakers in parallel, then, would result in a total impedance of 4 ohms. Most amplifiers are designed to have a total load impedance of 4 ohms or higher, but not lower than 4 ohms.

Multiple speakers can also be wired to a single output in series. Using this method, you would connect the plus output of the amplifier to the plus connection of the first speaker. The minus connection of that speaker is then connected to the plus connection of the second speaker, and so on.

Connecting speakers in series has its drawbacks as well. Unlike connecting speakers in parallel, connection them in series actually increases the impedance load, so connecting two 8-ohm speakers in series results in an overall impedance load of 16 ohms.

In addition, if a single speaker wire is disconnected, the entire chain will go out. It is possible to connect speakers in a combination of series and parallel to maintain the impedance load. At the same time, though, daisy chaining monitors requires that they incorporate DisplayPort 1.

If your equipment meets the requirements, the rest is simple. Follow the same procedure for each additional monitor. For the last monitor in the chain, disable DisplayPort 1. The number of monitors that can be daisy-chained together is limited by the resolution, timings, and refresh rates of those monitors.